In this manual, we are going to go through the process of replacing a broken handwheel thread. This will typically occur when the TankMaster has been left exposed to the elements over a long period of time...
It can be difficult to tell if you have water in your heating oil tank until something goes wrong with your Aga or boiler. This is one thing that should be checked on a regular basis...
Domestic Oil Fired Appliances and Systems This guide refers to all types of oil fired appliances including boilers, cookers and stoves and outlines the basic principles of these appliances. Appliance Types Designed to be strong and long lasting, oil...
Domestic Oil Storage This guide applies to oil storage tanks up to 3500 litres capacity supplying oil to single family dwellings for heating and cooking purposes. Depending on where you live, regulations may vary slightly. The information here...
Guide to Flues, chimneys and ventilation The guide applies to flues, chimneys and ventilation required for any oil fired appliance, including boilers, cookers and stoves used in the home, by the use of draught stabilisers and flue...
Fuel Transfer Pumps Here at Fueldump we now have available the complete range of FMT fuel transfer pumps. FMT are a Swiss/German company who produce only the best in fuel transfer pumps and flowmeters. As we all...
Most Diesel Transfer Pumps are Rotary Vane Pumps…. A rotary vane pump is a positive-displacement pump that consists of vanes mounted to a rotor that rotates inside of a cavity. In some cases these vanes can be...
Installing the Tanktop Please read these clear instructions for fitting your Atkinson Tanktop, Top Off Take Valve. Steel Tank: With the back nut still on, dress the Tanktop 1” BSP thread with PTFE tape. Thread the float and the suction...
The TANKMASTER is supplied for connecting to 10mm dia oil line. See Note 2 below if other pipe sizes are to be fitted. THE TANK SHOULD BE INSTALLED WITH AT LEAST 30CM (ONE FOOT) CLEARANCE UNDER THE...
Model No TA1055: 9v BatteryOverfill/Bund Alarm Installation ALL ELECTRICAL WIRING SHOULD BE PERFORMED BY A COMPETENT ELECTRICIAN. 1) Install the probe into the tank as illustrated below. You will require 2 holes approximately 20mm (3/4”) Dia NOTE: When drilling holes...
